Getting
Started: Instructions for Sequencer
Sequencer
Instructions
1.
Turn on the power by rotating the VOLUME/POWER knob to mid-position.
2.
Slide the PLAY/RECORD switch to the REC 1 position. This will record your
series of messages into level one.
3.
Press down on the Sequencer and speak your message clearly, about 12
inches away, into the side of the Sequencer marked MIC, holding the switch until
the message is finished.
4.
To record your next message on the same level press again and record your
message. Continue recording until the series is finished.
5.
If you want to record a second level of messages, slide the PLAY/RECORD
switch to the REC 2 position. Record your messages as you did for level one.
6.
When finished recording, slide the PLAY/RECORD switch to the PLAY 1
position. Press down on the Sequencer and your first message will play back.
Press down again and your second message will play. Continue pressing to play
back each message in sequence.
7.
To access the second level of messages, slide the PLAY/RECORD switch to
the PLAY 2 position.
8.
To re-record a message, simply repeat the above steps. Both levels must
be recorded at the same time. For example, if you want to change the messages on
level 2, you must also re-record the messages on level 1.
9.
For those individuals who are unable to access the Sequencer, any
external switch may be plugged into the jack marked EXT SWITCH. A message can
also be recorded utilizing an adaptive switch rather than the top of the
Sequencer, and following the above steps.
Notes:
Turn
off when not in use.
When changing battery, replace
within 5 minutes of taking the old battery out to retain your messages.
To eliminate the “clunking”
sound at end of each recording, attach an external switch such as a Big Red
Switch or Pal Pad to the Sequencer and when recording your message hold down the
external switch to record instead of the Sequencer.